生产线解说词英文配音

Before starting, check whether gear oil in gear box is sufficient through sightglass. If it is lower than the red line, add gear oil (LCKC 220) until the oil level reaches above the red line.

Set the temperature of the oil temperature machine and start its heating, and start the oil pump; (replacement figure 1)

Set the barrel temperature and mold temperature according to the production process and turn on the heating button;

After barrel temperature, mold temperature and oil temperature machine temperature reach the set values, start the main motor and material feed motor, and  increase the rotation speed gradually;

Observe the plasticizing effect of the raw material through the vacuum eye hole, adjust the feeding speed until the material changes from powdery status to slightly agglomerated status, and fit in the vacuum plug;

Turn on the vacuum pump circulation valve, start the vacuum pump, turn on the vacuum exhaust valve, and observe the vacuum gauge pointer until the indicated value is larger than 0.08;

Pass the haulage rope for the auxiliary haulage plate through the calendar along the direction of the product on the production line, and get ready for plate haulage;

After the plasticizing effect of the product from the mold is achieved, perforate the end of the product with a blade, tie the haulage rope through the hole, and allow compressed cool air to blow around the hole to quickly solidify the periphery of the hole so as to prevent the product from breaking from the hole position.

Gently pull the haulage rope and start the motors of the five rollers of the calendar to make the product smoothly pass through the calendar until the product reaches the position of the tractor.

Move the calendar towards the direction of the die to approach the die opening, fine-tune the rotating speeds of the main motor, material feeding motor, calendar five rolls and tractor to synchronize the front and rear rotating speeds; press the synchronous speed-up button to increase the running speed while observing the flow state of the products. Fine-tune the rotating speeds of the main motor, material feeding motor, calendar five rollers and tractor to synchronize the front and rear rotating speeds.

Observe the discharging condition of the product from the mold opening and adjust the choke screw of the mold until the products are discharged smoothly;

Measure whether the thickness of the product meets the product requirements. If there is any deviation, adjust the pressures of the first and second rollers of the calendar until the thickness of the product meets the product requirements. At the same time, fine-tune the rotating speeds of the five rollers of the calendar and the tractor to synchronize the front and rear rotating speeds.

After the products are discharged stably, place the color film and wear-resistant layer along the unwinding path to the third roller of the calendar for bonding, and set the tension controller and deviation correction controller to the automatic operation state at the same time;

Synchronous register operation is self-developed by Boyu and is easy to operate.

ccess the synchronous register interface, and enter the circumference of the color film plate and the embossing roller;

Determine the "origin" and check whether the signals from the two color scale sensors are normal;

Switch to the "Register ON" state and turn on the "One-key Register"; wait till the system automatically switches to the "Automatic Compensation Enabled" state, press the five rollers tightly;

If the indentation is more than one mark ahead, conduct mark reduction, and if the indentation is more than one mark behind, conduct mark addition; if the deviation is less than one mark, modify the 5-roller reference position when color code 2 is triggered until the register is completed;

Setting the product length: Adjust the position of the photoelectric switch before the plate shearing machine so that the distance between the blade of the plate shearing machine and the photoelectric switch is the required length of the product; (replacement figure 2)

Adjust the position of the suction cup of the plate lifting machine according to the length of the product.